[2024-feb-29] Sad news: Eric Layton aka Nocturnal Slacker aka vtel57 passed away on Feb 26th, shortly after hospitalization. He was one of our Wiki's most prominent admins. He will be missed.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
slackwarearm:development_refguide_di [2022/03/25 10:22 (UTC)] – mozes | slackwarearm:development_refguide_di [2024/01/21 12:28 (UTC)] (current) – [Brain Dump] Kernel module loader example mralk3 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | <note warning> | + | <note warning> |
+ | |||
+ | |||
+ | |||
Line 7: | Line 11: | ||
| Version | | Version | ||
| Author | | Author | ||
+ | |||
+ | ==== Brain Dump ==== | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | [[https:// | ||
Line 29: | Line 39: | ||
Using any of the build system referenced here requires the [[http:// | Using any of the build system referenced here requires the [[http:// | ||
+ | The Slackware ARM Development Kit is contained within the ' | ||
====== | ====== | ||
The boot loader employed on the RockPro64 and PineBook Pro is [[https:// | The boot loader employed on the RockPro64 and PineBook Pro is [[https:// | ||
+ | |||
+ | ==== Secure Boot ==== | ||
+ | |||
+ | Presently none of the bootware assets supplied by Slackware ARM are signed. | ||
+ | |||
+ | If the Hardware Model you're interested mandates Secure Boot, you'll need to figure this out for yourself. | ||
+ | |||
==== Trusted Firmware-A (ARM Trusted Firmware) ==== | ==== Trusted Firmware-A (ARM Trusted Firmware) ==== | ||
Line 49: | Line 67: | ||
==== Recovery / Initialisation SD Card image ==== | ==== Recovery / Initialisation SD Card image ==== | ||
- | * Needs script work to create one | ||
==== U-Boot configured to boot from SPI Flash ==== | ==== U-Boot configured to boot from SPI Flash ==== | ||
Line 68: | Line 85: | ||
^ Script | ^ Script | ||
- | | / | ||
- | | / | ||
| / | | / | ||
| / | | / | ||
- | | / | + | | / |
+ | |||
+ | ==== Slackware ARM Post Installation Setup Scripts ==== | ||
+ | |||
+ | |||
+ | The Slackware ARM post installation setup scripts are contained within '' | ||
+ | |||
+ | ''/ | ||
+ | |||
+ | These post installation setup scripts are to configure the Operating System, but the scripts are not part of any Slackware package (unlike the rest of the post installation scripts within Slackware). | ||
+ | ^ Script | ||
+ | | bootloader-flash | Installing the Boot Loader onto SPI Flash | Not Raspberry Pi | | ||
+ | | setconsole | ||
+ | | os-initrd-mgr | Configures the OS InitRD (Operating System Initial RAM Disk) | All | | ||
+ | | removeinstaller | Removes the Slackware Installer from the /boot partition | All | | ||
+ | | hwm-os-configure | Helper launch script for Hardware Model-specific configuration (see below) | - | | ||
- | ==== Operating System Configuration (per Hardware Model) | + | == Operating System Configuration (per Hardware Model) == |
- | / | + | '' |
This runs helper scripts found within the Slackware Installer. | This runs helper scripts found within the Slackware Installer. |