[2024-feb-29] Sad news: Eric Layton aka Nocturnal Slacker aka vtel57 passed away on Feb 26th, shortly after hospitalization. He was one of our Wiki's most prominent admins. He will be missed.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
howtos:software:arpwatch [2018/04/11 02:38 (UTC)] – [Configuration] mralk3 | howtos:software:arpwatch [2018/04/11 03:01 (UTC)] – [Sources] mralk3 | ||
---|---|---|---|
Line 25: | Line 25: | ||
</ | </ | ||
===== Update MAC Address Database ===== | ===== Update MAC Address Database ===== | ||
- | The README.ethercodes installed with Arpwatch SlackBuild indicates that the MAC Address database that comes with the source tarball can be outdated. | + | The README.ethercodes installed with the Arpwatch SlackBuild indicates that the MAC Address database that comes with the source tarball can be outdated. |
//These steps are covered in greater detail if you read / | //These steps are covered in greater detail if you read / | ||
Line 37: | Line 37: | ||
===== Start and Stop at Boot ===== | ===== Start and Stop at Boot ===== | ||
- | The file **/ | + | The file **/ |
- | Continuing with the above example, lets assume you are running a wireless access point. Add this to /// | + | Continuing with the above example lets assume you are running a wireless access point. |
< | < | ||
if [ -x / | if [ -x / | ||
Line 46: | Line 46: | ||
</ | </ | ||
- | If you wish to run Arpwatch on multiple network cards edit /// | + | If you wish to run Arpwatch on multiple network cards adjust **/ |
< | < | ||
# Change eth0 and wlan0 to match your configuration | # Change eth0 and wlan0 to match your configuration | ||
Line 55: | Line 55: | ||
</ | </ | ||
- | It's important that Arpwatch is stopped cleanly when your system is shutdown or rebooted. | + | It's important that Arpwatch is stopped cleanly when your system is shutdown or rebooted. |
< | < | ||
touch / | touch / | ||
Line 68: | Line 68: | ||
Finally, mark **rc.local** and **rc.local_shutdown** as // | Finally, mark **rc.local** and **rc.local_shutdown** as // | ||
- | |||
< | < | ||
chmod +x / | chmod +x / | ||
Line 75: | Line 74: | ||
===== Wrap Up ===== | ===== Wrap Up ===== | ||
- | Assuming all steps were followed, you should have receive | + | Assuming all steps were followed you should have received |
< | < | ||
Line 85: | Line 84: | ||
hostname: < | hostname: < | ||
ip address: 192.168.151.170 | ip address: 192.168.151.170 | ||
- | ethernet address: | + | ethernet address: |
ethernet address: XX: | ethernet address: XX: | ||
| | ||
Line 103: | Line 102: | ||
<!-- Please do not modify anything below, except adding new tags.--> | <!-- Please do not modify anything below, except adding new tags.--> | ||
<!-- You must remove the tag-word " | <!-- You must remove the tag-word " | ||
- | {{tag> | + | {{tag> |