Welcome to the Slackware Documentation Project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
howtos:slackware_admin:grub_on_first_install [2013/11/13 08:19 (UTC)]
ruario [Setting up GRUB 2 on install (without rebooting)]
howtos:slackware_admin:grub_on_first_install [2013/11/13 09:01 (UTC)]
ruario
Line 2: Line 2:
 ====== Setting up GRUB 2 on install (without rebooting) ====== ====== Setting up GRUB 2 on install (without rebooting) ======
  
-There is GRUB in A series of Slackware-14.1. If you want to install GRUB immediately after install (and before restarting),​ below is a simple method that assumes you use traditional BIOS and MBR partitioning (if you plan to use GPT instead of MBR partition, refer to [[howtos:​slackware_admin:​installing_with_gpt_without_uefi#​grub_2|Grub 2 with GPT and a BIOS motherboard]] instead):+There is GRUB in A series of Slackware-14.1. If you want to install GRUB immediately after install (and before restarting),​ below is a simple method that assumes you use traditional BIOS and MBR partitioning (if you plan to use GPT instead of MBR partitioning, refer to [[howtos:​slackware_admin:​installing_with_gpt_without_uefi#​grub_2|Grub 2 with GPT and a BIOS motherboard]] instead):
  
 After the message: After the message:
Line 12: Line 12:
   # grub-install /dev/sda   # grub-install /dev/sda
   # grub-mkconfig -o /​boot/​grub/​grub.cfg   # grub-mkconfig -o /​boot/​grub/​grub.cfg
-**Note:​** ​This assumes you are using the disk /dev/sda, adjust ​as needed.+<note important>​This assumes you are using the disk /dev/sd**a**, adjust ​if this is not the case.</​note>​
   # exit   # exit
   # reboot   # reboot

In Other Languages
QR Code
QR Code howtos:slackware_admin:grub_on_first_install (generated for current page)