[2024-feb-29] Sad news: Eric Layton aka Nocturnal Slacker aka vtel57 passed away on Feb 26th, shortly after hospitalization. He was one of our Wiki's most prominent admins. He will be missed.

Welcome to the Slackware Documentation Project

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
howtos:hardware:arm:raspberrypi3_wap [2018/08/26 23:56 (UTC)] – [Hardware Requirements] bifferoshowtos:hardware:arm:raspberrypi3_wap [2018/08/28 19:26 (UTC)] – [Adapter detection] bifferos
Line 44: Line 44:
  
 ===== Adapter detection ===== ===== Adapter detection =====
 +
 +<note>
 +I advise to not connect and disconnect the hub from the Pi while it's running.  Instead, power it up with hub connected (and powered) and then connect and disconnect the Wifi adapter as needed.
 +</note>
  
 Ensure that iwconfig shows two adapters wlan0 and wlan1.  wlan0 is the built-in one on the Pi.  If dmesg isn't showing the Alpha one has been plugged in, then just un-plug it and plug it in again.  Bring the Adapter up with: Ensure that iwconfig shows two adapters wlan0 and wlan1.  wlan0 is the built-in one on the Pi.  If dmesg isn't showing the Alpha one has been plugged in, then just un-plug it and plug it in again.  Bring the Adapter up with:

Trace:

howtos:hardware:arm:raspberrypi3_wap ()