======= BeagleBone Black HowTo ======= Note this is not how to install Slackware on a BeagleBone Black, this is simply a Slackware version of the BeagleBone [[https://beagleboard.org/getting-started | getting-started]] guide. This was written using Slackware x86_64 14.2 The flash drive access came up automatically just like in their Step 1 Setting up the USB networking took a couple extra steps though. ===== Installing Drivers ===== The driver install is the same as in the Beagle Getting Started guide Step 2 Download, make executable and run [[https://beagleboard.org/static/Drivers/Linux/FTDI/mkudevrule.sh | mkudevrule.sh]] Next unplug the beaglebone if you plugged it in as specified in their step 1. I do this to see what network adapters I have before: root@darkstar:~# ls /sys/class/net eth0@ lo@ wlan0@ Now plug the USB in and wait a few seconds for the BeagleBone to boot and see what you have: root@darkstar:~# ls /sys/class/net eth0@ eth1@ lo@ wlan0@ So now I know the BeagleBone appears on eth1 Here is the only difference from the BeagleBone instructions, I had to manually set the IP and turn eth1 up: ifconfig eth1 192.168.7.1 up Now you can open the web browser link as in their step 3 [[http://192.168.7.2 | http://192.168.7.2]] ====== Sources ====== [[https://beagleboard.org/getting-started | getting-started]] {{tag>BeagleBone}}