The Wiki has moved to new hardware, and the old server died.

Welcome to the Slackware Documentation Project

This is an old revision of the document!

Chroot From Installation Media

Slackware is full of tools that can help when the system becomes unstable and cannot boot. One example, is upgrading the kernel image and forgetting to run lilo afterwards.

In order to gain access to your system without booting directly to it, it is possible to use an installation media such as CD1 or the DVD. Once the installation media loads and starts, you can change the media's root directory into a mounted hard-disk partition and use it as the root directory, thus running commands directly from it and affecting it.

Volume preperation

The examples here are vary basic and expect that the entire system is located in a single partition. If you have a different partition table, please make sure that you mount all the needed partitions with care.

In the simplest of examples, a single hard disk was partitioned locally, normally and it is not encrypted in any way. In this case, all you need to do is to make sure what is the partition's 'name' is and continue to the mounting section.

If this is not the case, and you are using LVM/EVMS or an encrypted volume you will need to prepare the volumes before you can mount and chroot into them:

To unlock your LUKS partition, you will need to 'open' it and give it a name with this command (sdxn as example): cryptsetup luksOpen /dev/sdxn crypted (any name will do). At this point you will be prompted to insert the pass-phrase to unlock the volume. This partition will be mapped to '/dev/mapper/crypted'.

For LVM volumes you need to make sure that the system can recognize and activate the volume. This is done by running the commands:

  • vgscan –mknodes : searches for logical volumes, this might take a while
  • vgchange -ay : activates the found volumes
  • If more than one group was found, you can select which one to activate with vgchange -ay groupName

Volume mounting

After the preparation stage we can continue to mount the volume(s). You can use /mnt as it is only needed if you are planning to run the setup program.

After we make sure which partitions are needed, we need to mount them:

mount /dev/<location> /mnt

Next, we need to prepare three virtual directories to be used by the environment. Those are /dev a directory with virtual files that represent hardware devices, /proc a directory with virtual files that represent processes and /sys which contains the kernel and other system files:

mount -o bind /dev /mnt/dev
mount -o bind /proc /mnt/proc
mount -o bind /sys /mnt/sys


Once the partition is mounted, we can chroot to it:

chroot /mnt /bin/bash
If LVM preperation was involved it might be necessary to re-run vgscan –mknodes and vgchange -ay as they were created inside the installation media's ramdisc and not in the mounted partition.

The bash prompt that you see here is a bash prompt started on your system. You can now work on this environment naturally. For example editing /etc/lilo.conf and executing /sbin/lilo will happen on your system, not from the installation media.


* Originally written by cmyster.
* LVM and LUKS information comes primarily from Eric's READMEs on your installation disc.

In Other Languages
Translations of this page?:
QR Code
QR Code howtos:slackware_admin:how_to_chroot_from_media (generated for current page)