[2024-feb-29] Sad news: Eric Layton aka Nocturnal Slacker aka vtel57 passed away on Feb 26th, shortly after hospitalization. He was one of our Wiki's most prominent admins. He will be missed.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
howtos:network_services:ethernet_bridging_with_openvpn [2018/03/11 21:28 (UTC)] – Add consolidation section bifferos | howtos:network_services:ethernet_bridging_with_openvpn [2018/03/13 00:56 (UTC)] (current) – [Bridging setup] bifferos | ||
---|---|---|---|
Line 102: | Line 102: | ||
IPADDR[0]="" | IPADDR[0]="" | ||
NETMASK[0]="" | NETMASK[0]="" | ||
- | USE_DHCP[0]=yes" | + | USE_DHCP[0]="yes" |
... | ... | ||
</ | </ | ||
Line 224: | Line 224: | ||
As I explained in the introduction, | As I explained in the introduction, | ||
- | First thing to do is switch off the ' | + | First thing to do is switch off (power down) the ' |
- | Next, we need to now assign an ip address to our ethernet bridge on the ' | + | Next, we need to assign an ip address to our ethernet bridge on the ' |
< | < | ||
Line 232: | Line 232: | ||
</ | </ | ||
- | Note we assign an address to the bridge, not eth1! Now we just need to run a dnsmasq instance on this br0 interface, to serve requests up to the VPN. Much like the ' | + | < |
+ | Now we just need to run a dnsmasq instance on this br0 interface, to serve requests up to the VPN. Much like the ' | ||
< | < | ||
Line 246: | Line 247: | ||
</ | </ | ||
- | At this point, rebooting the ' | + | At this point, rebooting the ' |